Standard Tracks; Super Tracks; Ice Cleat Kit (Part Nos. 625-20 & 825-20); Outboard Motor Bracket (Part No. 617-00) - Argo 6 x 6 Vanguard Operator's Manual

Argo off-road utility vehicle operator's manual
Table of Contents

Advertisement

CAUTION should be observed when operating in win-
ter conditions and a drop in temperature occurs. Snow
and slush accumulation in the track could freeze, re-
sulting in damage to the track system. Slush, snow and
ice accumulation should be cleared from the axles and
track periodically to prevent build-up.
CAUTION should be observed when using any track
system on an Argo. Make sure the steel connecting pins
are properly secured in each track segment. Failure to
secure the track pins in the segment can result in lower
body damage if the track pin moves out of the segment
toward the lower body.
EXTREME CAUTION must be observed when using
the track systems on icy surfaces. Steering and braking
effectiveness will be reduced. Reduce speed.
EXTREME CAUTION must be observed when cross-
ing ice-covered water. The vehicle may sink if it breaks
through the ice surface and fills with water. Make sure
drain plugs are securely in place and do not overload
the vehicle. Should the vehicle break through the ice,
attempt to back the vehicle out, taking care that water
does not enter the engine compartment. Refer to sec-
tion 5.7.1 of this manual for additional information on
safe operation on ice-covered water.

11.3.2 Standard Tracks

Standard Tracks are intended to extend the use of the Argo so
that it can be driven over softer terrain conditions such as mud,
swamp, muskeg and snow. The standard track system is well
suited for a wide variety of terrain conditions. However, for
deep snow conditions, the Super Track system will outper-
form the standard track system.

11.3.3 Super Tracks

Super Tracks provide the maximum "flotation" available for
the Argo. They are very effective in deep snow, swamp and
muskeg.
Care must be used while traveling over uneven ground condi-
tions. The extra width of the segments can lead to the seg-
ments tipping to one side on the tire to such an extent that the
tire guide forces the tire bead off the rim. SUPER TRACKS
ARE NOT RECOMMENDED FOR TRAVEL OVER LOGS,
STUMPS OR ROCKS.
SECTION 11
ACCESSORY INFORMATION
44
11.4 ICE CLEAT KIT (Part Nos. 625-20 & 825-20)
ARGO ice cleats are stamped steel cleats that bolt to the outer
edges of the Super Track segments to grip on hard pack snow
and ice to improve traction and stopping.
Make sure all passengers riding in an Argo equipped
with ice cleats are informed to keep hands, feet and cloth-
ing inside the vehicle, well away from the tracks and ice
cleats while the Argo is in motion. Serious injury or
death could result from getting caught by the ice cleats.
Installing Argo ice cleats or any other traction device
on the in-board side of the track segment, close to the
lower body, may cause damage to the lower body if con-
tact results while the vehicle is being driven.
11.5 OUTBOARD MOTOR BRACKET
(Part No. 617-00)
The outboard motor bracket accepts gasoline or electric out-
board motors of up to 9.9 horsepower. Long shaft models are
recommended to avoid cavitation during operation. When
selecting an outboard specifically for the Argo, consider a light-
weight 4 to 5 h.p. model for ease of handling, installation and
adequate propulsion. When traveling on land it is recom-
mended that the outboard motor be transported safely in the
rear compartment of the Argo.
Deformation of the body components adjacent to the
outboard motor bracket may occur when outboard mo-
tors are left installed in hot temperatures. Caution should
be observed when turning an outboard motor equipped
Argo on land. Since the rear of an Argo swings side-
ways during a turn, the motor could strike a person or
object causing injury or damage.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents