Alternator Kits (Part Nos. 650-60, 850-60 & 850-40); Alternator Kit For Conquest; Snow Plow Kit (Part No. 657-13); Amphibious Trailer (Part No. 695-75) - Argo 6 x 6 Vanguard Operator's Manual

The convertible top assembly is not designed to with-
stand the turbulence created while transporting the ve-
hicle with the top assembled in the 'up' position. Fold
the top down and secure it properly to the vehicle body
or remove it from the vehicle for high speed transporta-
tion.
Hearing protection is strongly advised when operating
the vehicle equipped with any convertible top assembly.
The following decal should be attached to the inside of the
windshield:
If this decal is not attached to the windshield, contact your
Argo retailer for a free-of-charge replacement. The part number
is 126-84.
11.17 ALTERNATOR KITS (Part No. 650-60 & 850-60
for the Vanguard, Vanguard2, Bigfoot & Response/Part
No. 850-40 for the Conquest)
The externally mounted, belt driven, 40 amp alternator is rec-
ommended when electrical accessories such as a winch are
added to the vehicle.
There is a red charge indicator light installed in the dash, to
the right of the ignition switch. If the red light comes on, the
alternator is not sending a charge to the battery. This may
simply be a result of low engine idle speed. If the light stays
on at vehicle operating speeds, have your Argo retailer serv-
ice the system soon.
SECTION 11
ACCESSORY INFORMATION
49
11.17.1 Alternator Kit for Conquest (Part No. 850-40)
Check the V-belt tension frequently to be sure belt deflection
is no more than 1/8" or 3 mm with approximately 6 lbs. or 3
kgs of force applied to the belt, halfway between the pulleys.
Adjust the belt tension as necessary. Failure to do so will
reduce the charge rate and lead to battery failure.

11.18 SNOW PLOW KIT (Part No. 657-13)

The snow plow assembly attaches to the front of the Argo at
two mounting brackets that bolt to the front axle bearing ex-
tension housings. The plow blade is raised and lowered by
operating the power winch in and out.
DO NOT STAND BETWEEN THE PLOW BLADE AND
THE FRONT OF THE ARGO. Injury could result if the
blade is raised.
The vehicle operator must observe caution when oper-
ating the vehicle and snow plow in the presence of oth-
ers. Injury could result if a bystander is struck when the
vehicle swings to turn or the blade is lowered onto some-
one's foot. Always be aware of the area being plowed.
Although there is a blade trip mechanism feature of the
blade, damage or operator injury could result from hit-
ting rocks, stakes or curbs hidden under the snow being
plowed.

11.19 AMPHIBIOUS TRAILER (Part No. 695-75)

The Argo four wheel amphibious trailer is designed as an ad-
ditional cargo carrier for any Argo model. It is not intended
for the transportation of people. Trailer load capacity is 600
lbs or 270 kgs at a recommended tire pressure of 4 psi.

11.19.1 Operating Precautions

Keep cargo low and centered in the trailer, especially if used
in the water. Secure the load in place to keep it from shifting
when traveling in uneven terrain. Avoid sudden stops when
towing the trailer downhill to prevent the trailer from collid-
ing with or passing the Argo.
Do not step on or place loads on the edge of the body over the
trailer wheels. This area of the trailer body is intended only as
a mud guard.
Follow the instructions listed in Section 6.4.5 of this manual
to service the axle bearings. Do not allow water and debris to
accumulate in the bottom of trailer body to avoid premature
bearing failure.