Parking Brake Assembly (Ce Kit Models Only - Argo S Service Manual

Brake System
ii Align the spline of the brake disc with those on the output shaft and slip the disc on
and up to the shoulder of the output. (See NOTE previous page)
iii. Re-position the cooling duct and and secure with the two 1/4"-20x1" phillip head
screws (CONQUEST MODELS) or retightening the gear clamp on the overhead
mounting bracket ( BIGFOOT & RESPONSE MODELS)
iv. Apply blue LOCTITE 242 to the threads of the brake disc mounting bolt and install
it along with the lockwasher and clamping washer.
2. Perform the servicing procedure, Installing the Idler Chains, in Section WA of this
service guide.
3. Perform the servicing procedure, Adjusting the Idler Chains, in Section WA of this
service guide.
4. Perform the servicing procedure, Hydraulic Brake Caliper Installation or Me-
chanical Brake Caliper Installation in this section of the service guide.
5. Perform the servicing procedure, Mechanical Brake Caliper Adjustment on all
Vanguard models.
6. Apply the brake at the steering lever to each brake disc, and torque each bolt to the
specified torque.
7. Perform the servicing procedure, Reinstalling the Firewall, in Section VB of this
service guide.
Parking Brake
Some vehicles may have an additional parking brake system installed. The following
illustrates and describes the assembly and components of the parking brake setup.
Parking Brake Assembly
1. Locate the caliper bracket and slip 2 of the longer mounting bolts through the
bracket. Install 2 long spacers to the bolts as illustrated in Photo BR-69 Be sure to
orient the brake bracket as shown. The top hole closest to the back edge of the
bracket should be facing towards you.
2. Assemble the bracket assembly to the right hand side of the power pack frame and
secure with 2 nylon locknuts. Photo BR-70
Ontario Drive & Gear Limited
PH.(519)- 662-2840 FAX (519)- 662-2421
Argo Service Manual
BR-40
www.odg.com