Procedure - During Monitoring - Nellcor OxiMax N-65 Operator's Manual

OXIMAX N-65 Operation
Procedure — During Monitoring
To change the pulse beep volume during monitoring:
Press the Up Arrow or Down Arrow button while
monitoring to increase or decrease the pulse beep
volume.
The Pulse Amplitude (blip bar) increments or decrements
as a relative indicator of the current volume. Attempted
adjustments outside the range generate an invalid key
tone.
The minimum pulse rate volume is none, or OFF (no blip
bar segments shows.) The maximum pulse rate volume is
ten (ten segments.)
The Beep Tone Volume Adjust indicator flashes when
the pulse beep volume is adjusted to zero.
44
Note: When the monitor times-out in 30
seconds, the parameter is set and the monitor
display returns to the monitoring mode.
O Max N-65 Operator's Manual
XI