Checking The Needle; Replacing The Needle - Brother 885-U26 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY

Checking the needle

Sewing with a bent needle is extremely dangerous
since the needle may break while the machine is
being operated.
Before using the needle, place the flat side of the
needle on a flat surface and check that the distance
between the needle and the flat surface is even.
2
a Flat side
b Needle type marking
■ Correct needle
To check the needle correctly, place the flat side
of the needle on a flat surface. Check the needle
from the top and the sides.
a Parallel space
b Level surface (bobbin cover, glass, etc.)
■ Incorrect needle
If the distance between the needle and the flat
surface is not even, the needle is bent. Do not use
a bent needle.
a Parallel space
b Level surface (bobbin cover, glass, etc.)
36
1
1
2
1
2

Replacing the needle

Replace the needle as described below. Use the
screwdriver and a needle that has been determined to
be straight according to the instructions in "Checking
the needle".
a Press ("Needle Position" button) once or
twice to raise the needle.
a "Needle Position" button
Turn off the sewing machine.
b
CAUTION
● Before replacing the needle, be sure to
turn off the sewing machine, otherwise
injuries may occur if
button) is accidentally pressed and the
machine starts sewing.
c Place fabric or paper under the presser foot to
cover the hole in the needle plate.
Note
Before replacing the needle, cover the hole
in the needle plate with fabric or paper to
prevent the needle from falling into the
machine.
1
("Start/Stop"