Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX
Symptom
Dust has accumulated in the feed
dogs or in the bobbin case.
The upper thread was not threaded
correctly.
A high-pitched
The bobbin case is scratched, or has
noise is made while
a burr on it.
sewing.
A bobbin designed specifically for
this machine is not used.
The needle has not been raised to the
The needle threader
correct position.
cannot be used.
The needle is incorrectly installed.
The presser foot that is used is not
appropriate for the type of stitch that
you wish to sew.
The stitch is not
The thread tension is incorrect.
sewn correctly.
The thread is tangled, for example, in
the bobbin case.
The feed dogs are lowered.
The stitch is too short.
The presser foot that is used is not
appropriate for the type of stitch that
you wish to sew.
The fabric does not
The pressure of the presser foot is
feed.
weak.
The thread is tangled, for example, in
the bobbin case.
Zigzag foot "J" is slanted on a thick
seam at the beginning of stitching.
The sewing lamp
The sewing lamp is damaged.
does not come on.
Nothing appears in
The brightness of the LCD is either
the LCD.
too light or too dark.
114
Probable Cause
Remedy
Clean the race.
Correct the upper threading.
Replace the bobbin case. Contact
your dealer or the nearest
authorized service center.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.
Press the "Needle Position"
button.
Correctly install the needle.
Attach the presser foot that is
appropriate for the type of stitch
that you wish to sew.
Adjust the tension of the upper
thread.
Remove the tangle thread. If the
thread is tangled in the bobbin
case, clean the race.
Slide the drop feed lever to the
right. (as seen from the rear of the
machine)
Lengthen the stitch length.
Attach the presser foot that is
appropriate for the type of stitch
that you wish to sew.
Turn the presser foot pressure dial
to the left to increase the pressure
of the presser foot.
Remove the tangle thread. If the
thread is tangled in the bobbin
case, clean the race.
Use the presser foot locking pin
(black button on the left side) on
zigzag foot "J" to keep the presser
foot level while sewing.
Contact your dealer or the nearest
authorized service center.
Adjust the brightness of the LCD.
Reference
page 100
page 27
–
page 21
page 30
page 36
page 98
page 51
page 100
page 86
page 53
page 98
page 40
page 100
page 58
–
page 20
Advertisement
Table of Contents
