Brother 885-U26 Operation Manual page 41

—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d Press the black button at the back of the
presser foot holder.
a Black button
b Presser foot holder
The presser foot holder releases the presser
foot.
e Place a different presser foot below the holder
so that the presser foot pin is aligned with the
notch in the holder.
Position the presser foot so the letter indicating
the presser foot type (A, G, I, J, M, N or R) is
positioned to be read.
1
2
a Presser foot holder
b Notch
c Pin
d Presser foot type
f Slowly lower the presser foot lever so that the
presser foot pin snaps into the notch in the
presser foot holder.
a Presser foot lever
b Presser foot holder
c Notch
d Pin
The presser foot is attached.
a
b
J
3
2
3
1
g Raise the presser foot lever to check that the
presser foot is securely attached.
When a stitch is selected, the icon for the
presser foot that should be used appears in
the screen. Check that the correct presser
foot is attached before starting to sew. If the
wrong presser foot is installed, turn off the
sewing machine, attach the correct presser
foot, and then select the desired stitch again.
4
For details on the presser foot that should be
used with the selected stitch, refer to "Stitch
Settings" (page 98).
4
Note
Buttonhole foot "A"
Overcasting foot "G"
Zigzag foot "J"
Monogramming foot "N"
Blind stitch foot "R"
Replacing the Presser Foot 39
1