Digital Timer Programming; Recording Timer - JVC HM-DT100U Instructions Manual

Digital Timer
Programming
This VCR allows you to set recording timer or viewing
timer of a digital program. You can also make use of the
Electronic Program Guide (EPG) on page 51 to set easy
record or easy view timer.
•
Turn on the VCR and the TV, and select the AV
mode on the TV.
•
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
VCR
CABLE
TV
/DBS
[DTV MENU]
[MENU]
ATTENTION:
When performing timer programming of a digital (ATSC)
program, the VCR must be set to the standby mode condition
10 minutes before the start time of a program.
As timer recording is performed based on the time
information of each program, timer standby and timer
recording may not be possible due to deviation in the timer
information of each program if the VCR is set to standby
mode within 10 minutes of the program start time. In such
cases, press [REC] to perform manual recording.

Recording timer

A
Load a cassette
Make sure the record safety tab is intact.
B
Access Digital Set Up screen
Press [DTV MENU].
C
A Press [D E] to move
B Press [OK] at "DIGI-
D
Access Timer Mode screen
Press [D E] to move the arrow to "Timer", then
press [G] to move the arrow to "Timer mode".
E
[JKHI]
Set record timer
[OK]
A Press [D E] to
B Press [FG] to select the individual items "Chan-
C Press [FG] to move the arrow to "Set Timer" upon
Access Digital Program screen
DIGITAL SET UP
DIGITAL PROGRAM
the arrow to "DIGI-
TAL PROGRAM",
then press [G] or
[OK].
MENU
TAL PROGRAM" to
EXIT
access the timer
screen.
•
The clock must be set to access the timer screen. If
you have not set the clock, an error message will
be displayed. Refer to page 15 for the clock setting
procedure.
•
When the received channel is not a digital (DTV)
channel, "CAN NOT SET ON THIS CHANNEL
SELECT DTV CHANNEL THEN RETRY" appears
on the screen.
•
When receiving digital broadcast, if the "DIGITAL
PROGRAM" is set to access the timer screen at the
same instant a blocked program or scene is
received, the timer screen will not be displayed.
In addition, if a blocked program or scene is
received while the timer screen is being displayed,
the timer screen will disappear from the screen.
select "Rec",
Program 2
then press [G]
or [OK].
nel", "Date", "Start Time", "End Time", "Weekly/
Daily" and "Stop mode", and [D E] to enter the
desired setting (channel, date, start time etc.).
•
The "Weekly/Daily" item allows you to choose
from a selection of "Once", "Weekly", "Mon-Fri"
or "Daily".
•
You can select between "Manual" and "Event"
for the "Stop Mode" item.
completing the necessary settings, then press [OK].
•
An mark appears in front of the program title.
49
EN
TUNER CLOSED CAPTION PARENTAL
DIGITAL PROGRAM
OK
SELECT WITH ARROW KEYS
THEN PRESS [OK]
SELECT
Timer List Controller
Timer
Rec
TIMER Timer mode
Channel Channel DTV 8-1
Date Date May 1 (Wed)
Start Time Start Time 2:30 PM
End Time End Time 3:30 PM
Weekly/Daily Weekly/Daily Once
Stop Mode Stop Mode Manual
Set Timer
OK BACK DTV MENU
Select Operate Back Exit