S-Video/Video Connections - JVC HM-DT100U Instructions Manual

82
EN
S-VIDEO/VIDEO
Connections
Various connection for editing tapes
The following three methods can be used for editing
tapes.
•
VHS to S-VHS editing (VIDEO-VIDEO connection):
Although the picture quality is inherently limited by the
original VHS quality, the edited tape has better picture
quality than those made by VHS-to-VHS editing.
•
S-VHS to VHS editing (VIDEO-VIDEO connection):
Since the original source is recorded in S-VHS mode, the
edited tape has better picture quality than those made by
VHS-to-VHS editing.
•
S-VHS to S-VHS editing (S-VIDEO connection):
Original picture quality of S-VHS made can be duplicated
with minimal picture degradation. This is the best editing
method you can use on S-VHS VCRs.
A You can use a camcorder as the playback device
and your VCR as the recording VCR.
This VCR (for recording)
IN F–1
To [AUDIO]
input
To [S-VIDEO] input
Audio cable
(supplied)
S-video cable
(supplied)
To S-video
output
To rear panel
[REMOTE PAUSE/AV
COMPULINK]
Mini-plug cable (not
supplied)
(JVC camcorder only)
To Audio
output
To EDIT
DV camcorder
(for playback)
B You can use your VCR as the playback or
recording VCR.
E.g. When using this VCR as the recording VCR
This VCR (for recording)
i.LINK IN/OUT HDMI OUT OPTICAL
DV IN
S400
D-THEATER
PCM/STREAM
REGION 1
DIGITAL AUDIO OUT
To AUDIO
output
Another VCR (for playback)
NOTE:
When using this VCR as the playback VCR,
During playback, if the images cannot be displayed on the
TV, press [HDMI] on the front panel to turn off the [HDMI]
LED and set "TV OUTPUT 2" to "ALLto480i" (
In event when even the main menu screen cannot be
displayed on the TV when [MENU] is pressed, power off this
VCR, press and hold [PAUSE (
then power on the VCR again.
A
Make connections
A Connection with the camcorder
Connect an audio/S-video cable between the
camcorder's audio/S-video output connectors
and your VCR's [AUDIO/S VIDEO] input
connectors.
•
When the JVC camcorder is equipped with
the Master Edit Control, you can control the
VCR from the camcorder. Connect the mini-
plug cable (not supplied with this VCR) as
illustrated on the left.
•
When using a camcorder with a monaural
output, connect the audio output connector
on the camcorder to the [AUDIO L] input
connector on this VCR.
NOTE:
If the camcorder does not have S-video output
connector, use a video cable.
EDITING (cont.)
ATSC IN
S-VIDEO S-VIDEO
VIDEO VIDEO
Y
P /C L L
B B
AUDIO AUDIO
CABLE BOX
P /C R R
R R
L-1 L-2
COMPONENT
OUTPUT INPUT REMOTE PAUSE/
VIDEO OUT
AV COMPULINK
To [AUDIO To [S-VIDEO
INPUT] INPUT]
Audio cable
S-video cable
(supplied)
(supplied)
To S VIDEO
output
A
page 67).
W
)] for more than 5 seconds,
VHF/UHF
ANTENNA
IN
OUT
ANTENNA