JVC HR-J692U Instructions Manual

JVC HR-J692U Instructions Manual

Jvc video cassette recorder instructions

Advertisement

LPT0729-001B
COPYRIGHT © 2002 VICTOR COMPANY OF JAPAN, LTD.
Dear Customer,
Thank you for purchasing the JVC VHS video cassette recorder.
Before use, please read the safety information and precautions to
ensure safe use of your new VCR.
CAUTIONS
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
CAUTION:
This video cassette recorder should be used with AC 120V
60Hz only.
To prevent electric shocks and fire hazards, DO NOT use any
other power source.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION:
POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA
LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU
FOND.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
VIDEO CASSETTE RECORDER
HR-J692U
,
d
— 1 —
INSTRUCTIONS
NOTE:
Change or modifications not approved by the party responsible
for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for
help.
Caution on Replaceable lithium battery
The battery used in this device may present a fire or chemical
burn hazard if mistreated. Do not recharge, disassemble, heat
above 100°C or incinerate.
Replace battery with CR2032. Panasonic (Matsushita Electric)
or Maxell is recommended.
Danger of explosion or Risk of fire if the battery is incorrectly
replaced.
Disposed of used battery promptly.
Keep away from children.
Do not disassemble and do not dispose of in fire.
Declaration of Conformity
Model Number:
HR-J692U
Trade Name:
JVC
Responsible Party:
JVC Americas Corp.
Address:
1700 Valley Road Wayne, N.J. 07470
Telephone Number: 973-317-5000
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Printed in China
1102-AH-PJ-BJ

Advertisement

Table of Contents
loading

Summary of Contents for JVC HR-J692U

  • Page 1 LPT0729-001B COPYRIGHT © 2002 VICTOR COMPANY OF JAPAN, LTD. Dear Customer, Thank you for purchasing the JVC VHS video cassette recorder. Before use, please read the safety information and precautions to ensure safe use of your new VCR. CAUTIONS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage”...
  • Page 2: Important Product Safety Instructions

    … on a surface that is unstable or subject to vibration. 2. DO NOT block the VCR’s ventilation openings. 3. DO NOT place heavy objects on the VCR or on the Remote. 4. DO NOT place anything which might spill on the top of the VCR or on the Remote.
  • Page 3 Point the Remote towards the remote sensor on the target component. The maximum operating distance is about 8 m. To operate a JVC TV, use any of the following buttons: TV POWER, TV INPUT, TV CH+/– or TV VOL +/–.
  • Page 4: Buttons, Connectors And Indicators

    Front Panel VIDEO/AUDIO input connectors Display panel Play indicator Record indicator Rear Panel AC power cord Cassette loading slot Infrared beam receiving window Timer mode indicator Channel and auxiliary input/Clock timer — 4 — VCR mode indicator CONTINUED ON NEXT PAGE...
  • Page 5: Connections And Plug&Play Setting

    “ON”( pg. 12), you can see the current VCR status on the TV screen. Press OSD (OK) again to exit on-screen display. The indications are not recorded even if the VCR is in the recording mode. CH125 12:00 AM STEREO –WARNING–...
  • Page 6: Initial Settings

    Final preparation for use Turn on the TV. Select the VCR channel 3 or 4 (or AV mode) on the TV. You can now perform basic playback or basic recording. If you connect the TV and the VCR only using the RF connection ( pg.
  • Page 7: Tuner Setting

    The clock set manually will be lost after a power failure occurs. Tuner Setting Turn on the VCR and TV, and select the VCR channel (or AV mode). Setting channels automatically — Auto Channel Set Perform Auto Channel Set only if channels have not been set correctly by the Plug&Play setting.
  • Page 8: Basic Playback

    Playback Basic Playback Turn on the VCR and TV, and select the VCR channel (or AV mode). Load a cassette Make sure the window side is up, the rear label side is facing you and the arrow on the front of the cassette is pointing towards the VCR.
  • Page 9: Basic Recording

    Remote. NOTE: If the tape reaches its end during recording, the recording stops and “ EJECT (0) on the VCR to eject the tape or press REW (3) to rewind the tape. — 9 — or the Number keys. pg. 5), press TV/VCR on the ).
  • Page 10: Recording Features

    – Recording – Recording Features Turn on the VCR and TV, and select the VCR channel (or AV mode). Specifying recording length — Instant Timer Recording (ITR) During recording, press REC ( ) on the VCR repeatedly until the recording length you want appears on the display panel. The record indicator ( ) on the display panel starts blinking.
  • Page 11: To Use The Vcr While It Is In Timer Recording Standby Mode

    – Timer Recording – To use the VCR while it is in timer recording standby mode Press TIMER, then press POWER. After you use the VCR, press TIMER again to put the VCR into timer recording standby mode. Checking, canceling or changing...
  • Page 12: Other Functions

    (on-screen display) appears on the screen. NOTE: When you use this VCR as the playback VCR for editing a tape, be sure to set this function to “OFF”; otherwise, the VCR status information (on-screen display) will be recorded on the edited tape.
  • Page 13 ( Editing You can use your VCR as the playback or recording VCR. You can use a camcorder as the playback VCR and your VCR as the recording VCR. Refer also to the other components’ instruction manuals for connection and its operations.
  • Page 14: Specifications

    Specifications GENERAL Power requirement : AC 120 V Power consumption Power on : 13 W Power off : 1.5 W Temperature Operating : 5°C to 40°C (41°F to 104°F) Storage : –20°C to 60°C (–4°F to140°F) Operating position : Horizontal only Dimensions (W x H x D) : 435 mm x 94 mm x 248 mm (17-3/16"...
  • Page 15: Warranty (Only In U.s.a.)

    WHAT WE WILL DO: f this product is found to be defective within the warranty period, JVC will, at its option, either repair or replace the defective part(s) or replace the product with a new or refurbished functionally equivalent product. Within 90 days from date of retail sale, repair or replacement will be at no charge.
  • Page 16 Sophisticated electronic products may require occasional service. Just as quality is a keyword in the engineering and production of the wide array of JVC products, service is the key to maintaining the high level performance for which JVC is world famous. The JVC service and engineering organization stands behind our products.

This manual is also suitable for:

Hr-j692ucHr-j692us

Table of Contents