Installing Smart Board Software; Configuring The Interactive Whiteboard - Smart Technologies SMART Board 2000i-DVX Installation Manual

To adjust the resolution setting for your Macintosh computer (Mac OS X
operating system)
1. Press the System Preferences icon in the Dock.
2. Double-press Displays.
3. Select 800 × 600 (for a 2000i-DVS) or 1024 × 768 (for a 2000i-DVX) and close the dialog box.

Installing SMART Board Software

The 2000i comes with a SMART Board software CD so you can install SMART Board software on
any computer.
IMPORTANT
During the installation process, you should select the option to start the SMART
Board tools automatically when you start your computer. This ensures that the
interactive whiteboard is fully functional whenever you start your computer.
The SMART Board tools are open if you can see the SMART Board icon in the system tray
(Windows computers) or in the Dock (Macintosh computers).
To install SMART Board software
1. If you haven't already done so, turn on the computer and the projector. To turn on the
projector, press the Lamp On button on the control panel.
NOTE: If the projector is off, press the projector's Power button.
IMPORTANT If you're using a USB adapter and your computer can't find the appropriate
driver for it, unplug the USB adapter from your computer, install SMART Board
software and then reconnect your USB adapter.
If the Found New Hardware wizard appears, point the wizard to the SMART
Board software CD for it to locate the correct driver.
2. Close all open applications on the computer.
3. Insert the SMART Board software CD into your CD drive.
The installation starts automatically. Follow the on-screen instructions.
If the CD doesn't start automatically on a Windows computer, select Start > Run and enter
x:\autorun.exe (where x: is your CD drive). For Macintosh computers, click the SMART
Installer icon to open your CD drive and double-click the software application file.

Configuring the Interactive Whiteboard

Normally, the internal computer's serial or USB port is automatically detected by SMART Board
software, but you may need to manually configure the COM port if:
• the Windows operating system you're running does not perform plug and play (for example,
the Windows NT 4.0 or Me operating system)
• the Windows operating system fails to detect the new hardware
Finalizing the Installation 29