Maintenance And Service Safety Instructions And Practices - RHINO SM72 Operator's Manual

Maintenance and Service Safety Instructions and Practices

Make sure the PTO shield, integral driveline shields, and input shields
are installed when using PTO-driven equipment.
shield if it is damaged or missing.
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement.
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause
immediate entanglement, injury or death.
Never interfere with factory-set hydraulic calibrations.
cause a failure of the equipment and may result in injury.
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running.
SM72 02/10
© 2012 Alamo Group Inc.
SAFETY
(S3PT-8)
Place the Implement on the ground or securely
(S3PT-09)
(S3PT-11)
Do not permit anyone to modify or alter this
(SG-14)
(SG-20)
Safety Section 1-14
Always replace any
Any change in calibration could
(SBH-13)
(SG-8)
(SG-5)