Blade Sharpening - RHINO SM72 Operator's Manual

BLADE SHARPENING

Replace bent or broken blades with new blades. NEVER ATTEMPT TO STRAIGHTEN,
WELD, OR WELD HARDFACING ON BLADES SINCE THIS WILL LIKELY CRACK OR
OTHERWISE DAMAGE THE BLADE WITH SUBSEQUENT FAILURE AND POSSIBLY
CAUSE SERIOUS INJURY FROM THROWN BLADES.
Always sharpen both blades at same time to maintain balance. Follow original sharpening pattern as shown in
Image Mnt-R-0008. Always sharpen blades by grinding. DO NOT heat and pound out edge. Do not sharpen
blade to a razor edge, but leave a 1/16" blunt edge. Do not sharpen back side of blade.
Avoid personal injury. Always block the mower up to prevent if from falling when the blades
and/ or carrier are being serviced.
Avoid personal injury. Always wear safety glasses and face protection when grinding blades.
SM72 02/10
© 2012 Alamo Group Inc.
MAINTENANCE
Blade Maintenance
Maintenance Section 5-5
(SGM-10)