Page 1
650 S. Royal Lane, Suite 100 Coppell, TX 75019 (800) 486-4892 8:00 to 5:00 CST (Central Standard Time) Toll Free Fax: (877) 304-1728 email: customerservice@craftmade.com www.craftmade.com P. O. Box 1037 650 S. Royal Lane, Suite 100 Coppell, TX 75019 EE.UU.
Page 2
Read and Save These Safety Precautions What You Have Turn off electricity at main switch before wiring or servicing fan in order to avoid possible electrical shock. Parts Quantity All wiring must be in accordance with the National Electric Code (ANSI/NFPA 70-1999) and local electrical codes.
Page 3
Wood Screws (S1) Downrod Installation B. Angle Mount Canopy Screws (S2) (Normal Ceilings) Craftmade Part #45AD (see dealer) IMPORTANT: If using the angle mount Step 5 method, check to make sure the ceiling angle is not steeper than 35°. Angles greater Downrod Installation than 35°...
Page 4
Step 6 Step 7 For added security, attach safety cable from fan unit to "J" hook (S9) Position downrod so the hole in the downrod aligns with the hole in the in outlet box. Secure by looping zip tie (S10) through safety cable and coupling on the motor.
Page 5
Step 8 Step 9 1. Connect fan wires to ceiling wires: white fan wire to white outlet Attach canopy (3) to the Ceiling wire, black to black and green to green. Wire connectors (S6) are mounting bracket by placing provided for your convenience. If an additional blue wire is present then screws (S2) into slot in Canopy (3) also connect the blue wire to the black wire.
Page 6
Step 11 Operation Instructions 5 Blade Installation 1. The sequence of operation for the motor pull/chain switch is Remove rubber cushions, saving OFF-HI-MED-LOW. motor screws for blade 2. Push the slide switch RIGHT for FORWARD, and LEFT for installation. Using motor screws REVERSE action of the blades.
Page 7
Electrical Connections Electrical Connections Continued… Connect black and blue (if provided) fan wires to black outlet wire. Connect white fan wire to white outlet wire and green grounding lead Ground wire from the grounding conductor to the supply circuit (see figure A). Use wire connectors provided with your fan.
Need help?
Do you have a question about the OPXL52 and is the answer not in the manual?
Questions and answers