Navico mx420 Operator's Manual page 87

Operator's Manual
Press the Display Options softkey.
The following choices are available:
74
Show Boat - Yes is the default condition, which places the boat
icon in the middle of the screen. No places the boat in a Compass
Rose in the upper right corner of the screen (see the diagram be-
low), where your direction is indicated by the boat in the Compass
Rose. The boat's position is then indicated by an X in the center of
the screen.
Show All Waypoints - Yes is the default condition, which displays
all waypoints, where the first character of the description is a sym-
bol, in its proper location relative to the boat's position. No causes
none of the waypoints to be displayed.
Show Active Route - Yes is the default condition, which causes the
active route (course lines) and its waypoint symbols to be dis-
played. No causes the course lines not to be displayed. Note that
these lines can only be displayed in Rhumb Line navigation mode
(see CFG1 Navigation).
Show Recorded Track - Yes is the default condition, which causes
the course you have already traveled to be displayed. No causes
the traveled course not to be displayed.
Show Off Track Limit - Yes is the default condition, which causes
the active route cross-track error lines to be displayed. These are
Plot
Version 2.0