Table of Contents
Advertisement
Operator's Manual
Before you adjust your position, set your WPT Pass Criterion to Dis-
tance in the CFG1 Navigation screen. To adjust your position, pick a
point near your first waypoint. A distance of 1 or 2 miles from the first
waypoint is good to start with. Go to the POS1 screen and press E.
Next, press the NAV function key, then the E key. Press the Reset XTE
softkey. Press the E key. This resets your cross-track error and up-
dates the active route in RTE1 with the adjusted position.
Now just use the CDU as you normally would. You can output NMEA
0183 data records to other devices. Be careful, however, other instru-
ments will interpret the data as completely valid. So, don't run the
Demonstration Mode while you are underway and connected to de-
vices that are being used in real time, like your autopilot.
194
Demonstration Mode
Version 2.0
Advertisement
Table of Contents
