Navico mx420 Operator's Manual page 40

Navigate Operator's Manual
Below this information, you will find your Set and Drift data, which is
calculated using GPS and your compass and speed sensor inputs.
Reset XTE and Skip Waypoint, described at the end of NAV2, is also
available in NAV4.
The window on the right displays depth information coming from the
depth sounder unit using the NMEA 0183 record of DPT, DBS, DBT, or
DBK. These are setup in the CFG1 Depth screen, refer to the Con-
figuration section of the manual and the Installation & Service Manual
for full details on depth data.
Below the depth data you will find the next route leg vector, the Range
to the waypoint and Time To Go data, explained in the NAV3 section.
Note: The NAV screens are not active until antenna is detected.
Version 2.0
27