Using The Powered Subwoofer; Operating The Powered Subwoofer - JVC VS-DT2000 Instructions Manual

Using the Powered Subwoofer

STANDBY/ON
indicator
Operating the Powered
Subwoofer
Presetting the Volume
You need to preset the volume level of this speaker (SP-
PW2000) to match those of the main speakers (SP-
VSDT2000). Once you preset the volume level, it is stored
as your reference level and the volume level of this speaker
will be able to automatically change as the volume level of
the Center Unit (CA-VSDT2000) changes.
1
Press the POWER button of the Sub-
woofer to turn on the power.
The STANDBY/ON indicator of the Subwoofer will
light in green.
2
Set the VOLUME of the Subwoofer in the
"MIN" position.
3
Adjust the volume of the Center Unit to
your listening level.
4
Adjust the VOLUME of the Subwoofer to
balance the volume with the main
speakers.
To turn off the Subwoofwer, press the POWER button
to light off the STANDBY/ON indicator.
15
Adding the Richness to the Bass (PHASE)
If you want to add the richness more to the bass, press the
PHASE button to set it either in the "
—
or the " NORMAL" position, whichever can add the rich-
ness to the bass.
Normally, the PHASE button should be set in the "
MAL" position.
Automatic Operating Status On/Off
To save energy, the Subwoofer enters the Standby mode if
no (or very weak) sound signals come into the Subwoofer
for about 5 minutes. In Standby mode, the STANDBY/ON
indicator of the Subwoofer lights in red.
When sound signals come in again, the Subwoofer enters
the Operating mode and reproduces the sounds. The
STANDBY/ON indicator will light in green again.
• The subwoofer may not turn on automatically from the
Standby mode in the following cases:
— when the VOLUME of the Subwoofer is set near "MIN"
position.
— when the volume of the amplifier is set to "0" or the
sound signals from the amplifier are extremely weak.
CAUTION:
• Be sure to turn off the POWER of the Pow-
ered Subwoofer when the Powered Sub-
woofer is not in use for an extended period
of time.
VOLUME
PHASE
INPUT (LOW-LEVEL)
INPUT (HIGH-LEVEL)
VOLTAGE SELECTOR
POWER
_
REVERSE" position
—
NOR-