Subscribe to Our Youtube Channel
Related Manuals for Petsafe Remote Trainer PDBDT-305
Summary of Contents for Petsafe Remote Trainer PDBDT-305
- Page 1 Remote Trainer operating and training guide Little Dog Model Number PDLDT-305 Big Dog Model Number PDBDT-305 Please read this entire guide before beginning...
-
Page 2: Table Of Contents
To get the most protection out of your warranty, please register your product within 30 days result in death or serious injury. at www.petsafe.net. By registering and keeping your receipt, you will enjoy the product’s CAUTION, used with the safety alert symbol, indicates a hazardous full warranty and should you ever need to call the Customer Care Center, we will be able to situation which, if not avoided, could result in minor or moderate injury. -
Page 3: Components
At the push of a button, your remote sends a signal activating your dog’s Receiver Collar. He receives a safe but annoying stimulation. He’ll quickly learn the association between his behavior Contact Receiver and your correction; in no time, you’ll have a better-behaved pet. The PetSafe Remote Trainers have ® Points Indicator been proven safe, comfortable, and effective for both small and large dog breeds. -
Page 4: Operating Guide
6. Reinstall the screws (2B, 2E). Do not over-tighten the screws. Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact the Customer Care Center or visit our website at www.petsafe.net for a list of common retailers. 2A (PDLDT-305) -
Page 5: Fit The Receiver Collar
It will be a tight fit. A slight change in your pet’s behavior, such as looking around in curiosity, scratching at his collar, or flicking his ears, indicates the Recognition Level that is best for him. US Customer Care Center 1-800-732-2677 www.petsafe.net... -
Page 6: Understanding The Remote Transmitter
Note: If your pet breaks the “Sit” command, repeat steps 3 through 6. Keep your pet close to you while teaching the “Sit” command. US Customer Care Center 1-800-732-2677 www.petsafe.net... -
Page 7: The "Come" Command
4. While your pet digs, press the Stimulation Only Button and release it when he stops digging. Only press the button while your pet is in the act of digging, and do not say anything to him. US Customer Care Center 1-800-732-2677 www.petsafe.net... -
Page 8: Chasing
5. When your dog stops chasing the object, immediately release the button, walk backwards and give the command “Come.” Praise your dog as he comes to you. 6. Repeat the process until your dog stops chasing the object. US Customer Care Center 1-800-732-2677 www.petsafe.net... -
Page 9: Frequently Asked Questions
• Your pet should be able to recognize basic obedience My pet does not respond when • Make sure the Receiver Collar has been turned on. be before using the PetSafe commands such as “Sit” or “Stay”. Pets should be at I press the Tone or Stimulation • If your range has reduced from the first time you used the... -
Page 10: To Pair The Remote Transmitter And Receiver Collar
Note: If the Test Light does not flash, install new batteries and re-test. If Test Light still does not conditions: (1) This device may not cause harmful interference, and (2) this device must accept flash, contact the Customer Care Center or visit our website at www.petsafe.net. any interference received, including interference that may cause undesired operation. -
Page 11: Customer Care International
Monday - Friday 10:30 AM - 7 PM This product has the benefit of a limited manufacturer’s warranty. Details of the warranty applicable to this product and its terms can be found at www.petsafe.net and/or are available by sending a stamped addressed envelope to PetSafe Ltd.
Need help?
Do you have a question about the Remote Trainer PDBDT-305 and is the answer not in the manual?
Questions and answers