Table of Contents
Advertisement
HORIZONTAL
Slightly loosen the adjustment screws and position the antenna so that the top of
the antenna pod is level, with the top of the pod horizontal to the sky as shown.
When the antenna is adjusted correctly, tighten the adjustment screws but be
careful not to overtighten them.
Continue with the next section for installations with exposed wiring, or the section
following for installations with hidden wiring.
Cable Installation
Once the antenna is mounted according to the previous instructions, you can
continue with the cable and Splitter portion of the installation:
1.
Take the RG-6 cable which you purchased to connect to the antenna and
thread one end of the cable through the opening in the end of the rubber
boot. Then connect the cable to the antenna pod as shown in the illustration
following.
2.
Slide the rubber boot over the cable connection to provide a weather proof
seal and install the cable tie around the cable directly below the rubber boot
to prevent the rubber boot from slipping down. Trim off the excess cable tie.
3.
Route the remainder of the antenna cable into the home or building to where
1
Antenna Pod
Adjustment
Screw
SKY
1
Adjustment
2
Screw
Home Distribution Kit Installation Manual
LEVEL
Advertisement
Table of Contents
