Table of Contents
Advertisement
(7) Replace blower plate onto the product. Secure blower unit with two screws, one through the blower
plate, and the other through oven back plate. Secure blower cover plate onto the product top with two
screws. (Fig. 1-3-5)
(8) Slide two tabs of ventilation exhaust covers
that two large openings are covered. Secure each with one screw
Make sure two tabs are inserted into square holes and the screw heads are not protruding from blower
cover plate surface.
Note: Exhaust Adaptor
wall. See STEP 2: USING THE TEMPLATE for details.
3. EXHAUST DUCT
The hood exhaust has been designed to match with a standard 3
If a round duct is desired, a rectangular-to-round transition adaptor must be used.
Note: Round duct elements with a 6" diameter are recommended.
MAXIMUM DUCT LENGTH
For satisfactory air movement (CFM) the total duct length should not exceed 130 feet (39.6 m) of 3
(8.3 cm × 25.4 cm) rectangular duct.
This 130 feet maximum can be comprised entirely of straight duct or the total amount of straight duct used
plus the equivalent amount in feet of elbows, transitions, wall or roof caps, etc. which were used. The drawings
below show approximate measurements for typical round duct elements [with a 6" (15.2 cm) diameter] and
rectangular duct elements 3
(3 m), and a transition adaptor, equivalent to 5 ft. (1.5 m), can be used with a maximum of 115 feet of straight
duct.
Transition Adaptor - 5 ft. (1.5 m)
90
O
Elbow - 25 ft. (7.8 m)
IP2386_38Q01CP_Eng_04_080105.indd 8
IP2386_38Q01CP_Eng_04_080105.indd 8
u
Blower Unit
Mounting Screws
Blower Unit
Blower Unit
Exhaust Parts
Fig. 1-3-5
must be secured onto bracket assembly
y
/
"×10" (8.3 cm × 25.4 cm). For example, a 90 degree elbow, equivalent to 10 ft.
1
4
Wall Cap - 40 ft. (12 m)
45
Elbow - 5 ft. (1.5 m)
O
into two small square openings of blower cover plate so
. (Fig. 1-2-5)
i
Blower Plate
Mounting Screws
Blower Plate
Back Plate
Blower Unit
Mounting Screws
a
/
"×10" (8.3 cm × 25.4 cm) rectangular duct.
1
4
90
O
Elbow - 10 ft. (3 m)
8
before installing it on the
/
"×10"
1
4
Roof Cap - 24 ft. (7.3 m)
45
O
Elbow - 5 ft. (1.5 m)
2009-1-6 Michael 9:16:49
2009-1-6 Michael 9:16:49
Hide quick links:
Advertisement
Table of Contents
