Connecting Speakers; Connecting Other Equipment - JVC UX-A52 Instructions Manual

Connecting Speakers

To connect speakers
You can connect the speakers by following the procedure
below:
1
2
Speaker terminals
SPEAKER IMPEDANCE
+
Speaker cord
R
–
Black
R
Rear of the right
speaker
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity: White cord to red (+) terminal and
black cord to black (–) terminal.
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker impedance—4 Ω to16 Ω.
3,4
Red
MIN 4Ω
+
Speaker cord
L
–
L
Rear of the left
speaker
To remove the speaker grilles
The speaker grilles are removable.
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.

Connecting Other Equipment

You can connect both of the analog and digital equipment.
When you connect and use the equipment, refer also to its
manual supplied.
• DO NOT connect other equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and
the OPTICAL DIGITAL OUT terminal.
OPTICAL DIGITAL OUT
terminal
Before connecting the other equipment,
remove the protective cap from the
terminal.
– 8 –
Continued
Holes
Projections
Speaker grille
Protective cap
Audio equipment with
an optical digital input