JVC UX-A52 Instructions Manual page 28

Jvc micro component system instructions
Hide thumbs Also See for UX-A52:
Table of Contents

Advertisement

Playing Back a Tape
You can play back type I, II, and IV tapes.
1
Press TAPE open/close 0 on the unit.
The unit automatically turns on, the electronic swing
panel slides downward, and the cassette loading slot
appears.
If a cassette is already in the cassette loading slot, it is
ejected.
2
Insert a cassette with the exposed part facing left.
The cassette is pulled in, then the electronic swing
panel slides upward automatically.
3
Press TAPE 2 3.
The tape starts playing.
• Each time you press the button, the tape direction
changes as follows:
: Plays the front side.
: Plays the reverse side.
Tape indicator
Tape direction
When the tape plays to the end, the cassette deck
automatically stops if the reverse mode is set to
. (See "To play both sides—Reverse Mode".)
To stop during play, press 7.
To fast-wind or rewind the tape, press ¢ or 4.
• When the tape direction is
• When the tape direction is
To eject the cassette, press TAPE open/close 0.
• After ejecting the cassette, press TAPE open/close 0
cassette loading slot
To play both sides—Reverse Mode
You can set the cassette deck to play just one side of a tape,
both sides once, or both sides continuously.
• You can set this mode only when a cassette is already in
On the remote control ONLY:
Press REV. MODE.
• Each time you press the button, the reverse mode
To check the clock time while playing back a tape
On the remote control ONLY:
Press DISPLAY (not on number buttons.)
• Each time you press the button, the source information
Reverse mode
or
– 23 –
¢ : Fast-winds the tape.
4 : Rewinds the tape.
4 : Fast-winds the tape.
¢ : Rewinds the tape.
again to close the electronic swing panel.
DO NOT press TAPE open/close 0 during tape play.
the cassette deck.
changes as follows:
: To only play back one side (front or reverse.)
: To play back the front and reverse sides once.
: To play back both front and reverse sides
continuously.
and the clock time alternate on the display.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ux-a52rCa-uxa52Sp-uxa52

Table of Contents