Av Compu Link Remote Control System - JVC RX-DP10VBK Instructions Manual

AV COMPU LINK Remote Control System

This receiver is equipped with the AV COMPU LINK-III. The AV COMPU LINK remote control system allows you to
operate JVC video components (TV, VCR, and DVD player) through the receiver. To use this remote control system, you
need to connect the video components you want to operate, following the procedure below.
• Refer also to the manual supplied with your video components.
1. If you have already plugged your VCR 1 (VCR connected to the VCR 1 jacks), DVD player, TV, and this
receiver into the AC outlets, unplug their AC power cords first.
2. Connect the IR signal transmitter (supplied) to the IR OUT on the rear, and place it so that it is aimed at
the remote sensor on the target video component(s).
• See "CONNECTIONS 1" below (and page 15 for details).
3. Connect your VCR 1, DVD player, TV, and this receiver as follows, using the cables with the monaural
mini-plugs (not supplied).
• See "CONNECTIONS 2" below.
4. Connect the audio input/output jacks on VCR 1, DVD player, TV, and this receiver using the cables with
RCA pin plug.
• See pages 11 to 13.
5. Connect the video input/output jacks on VCR 1, DVD player, TV, and this receiver, using the cables with
RCA pin plugs, with S-video plugs or with component video plugs.
• See "CONNECTIONS 3" on the next page (and pages 11 to 13 for details).
6. Plug the AC power cords of the components into the AC outlets.
7. When turning on the TV for the first time after the AV COMPU LINK connection, turn the TV volume to
the minimum using the TV volume control on the TV.
8. Turn on the other connected components first, then turn on this receiver.
• When turning on the VCR 1, use the remote control supplied with this receiver—press VCR 1
CONNECTIONS 1: IR Signal Transmitter Connection
RF REMOTE
ANTENNA
On the rear panel
BAND1
BAND2
IR OUT
CONNECTIONS 2: AV COMPU LINK Connection
VCR 1
DVD player
VHS
AV
COMPU LINK
Notes:
• The AV COMPU LINK remote control system cannot control the DBS tuner connected to the TV SOUND/DBS jacks, and video
components connected to the VIDEO and VCR 2 jacks on the receiver.
• When connecting only the VCR 1 or DVD player to this receiver, connect it directly to the receiver using a cable with the monaural mini-
plugs.
• When connecting the receiver and the TV with AV COMPU LINK EX terminal by using the component video cables, you cannot use
Automatic Selection of TV's Input Mode (see page 63).
61
Target video component(s)
At an angle of
approx. 60°
DVD
AV
COMPU LINK
RX-DP10VBK
IR signal transmitter
TV
AV
COMPU LINK EX
AV
COMPU LINK III
(STANDBY/ON).
CAUTION:
When connecting the TV with the
AV COMPU LINK remote control
system, connect the receive to the
AV COMPU LINK EX or AV
COMPU LINK III terminal.
DO NOT connect the receiver to
the AV COMPU LINK RECEIVER/
AMP terminal.