Connecting A Subwoofer - JVC RX-DP10VBK Instructions Manual

Basic connecting procedure
2
1
1 Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2 Turn the knob counterclockwise.
3 Insert the speaker signal cable.
4 Turn the knob clockwise.
Front speakers 1
Right / Left
FRONT 1 SPEAKERS
CAUTION :
SPEAKER
IMPEDANCE
HIGH
LOW
4 6 8 16
SPEAKER
RIGHT
LOAD SELECTOR

Connecting a subwoofer

You can enhance the bass by connecting a subwoofer.
Connect the input jack of a powered subwoofer to the
SUBWOOFER PREOUT jack on the rear panel, using a cable with
RCA pin plugs (not supplied).
4
3
FRONT 2 /
SUB ROOM SPEAKERS
LEFT RIGHT LEFT
Right /
Front speakers 2
Note:
You can connect two pairs of front speakers—one pair to the FRONT
1 SPEAKERS terminals, and the other pair to the FRONT 2 / SUB
ROOM SPEAKERS terminals.
The speakers connected to the FRONT 2 / SUB ROOM SPEAKERS
terminals can be used as follows:
• As the second front speakers in the main room
• As the front speakers in the sub-room when using the Multi-room
operations. (See page 17.)
CAUTION:
Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
IMPORTANT for the FRONT 1 SPEAKERS connection:
To obtain the best possible output power from the receiver, and to
prevent the receiver from being overheated, the receiver has the
SPEAKER LOAD SELECTOR which has to be set as follows:
• Set it to the "HIGH" position when the impedance of the front
speakers connected is within the range of 8
• Set it to the "LOW" position when the impedance of the front
speakers connected is within the range of 4
Center speaker
CAUTION :
SPEAKER IMPEDANCE 8 16
CENTER SURROUND
SPEAKER SPEAKERS
RIGHT LEFT
Right /
Surround speakers
Left
Powered
subwoofer
to 16 .
to 6 .
SURROUND BACK
SPEAKERS
+
–
RIGHT LEFT
Right / Left
Left
Surround back
speakers
FRONT
SUB
WOOFER
SURR
SURR
BACK
R L
PREOUT
CENTER
8