Connecting The Speakers And Subwoofer - JVC RX-5060B - AV Receiver Instructions Manual

Instructions
Hide thumbs Also See for RX-5060B - AV Receiver:
Table of Contents

Advertisement

Available languages

Available languages

AM antenna connections
AM EXT
AM
LOOP
ANTENNA
1
Outdoor single vinyl-covered wire (not supplied)
Turn the loop until you have the best reception.
Notes:
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl by twisting it as illustrated.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal. (Keep the AM loop antenna
connected.)
AM Loop Antenna
(supplied)
Snap the tabs on the loop into
the slots of the base to
assemble the AM loop
antenna.
2
Do not connect the AC power cord until all other connections
have been made.

Connecting the Speakers and Subwoofer

You can connect five speakers (a pair of front speakers, a center
speaker, and a pair of surround speakers) and a subwoofer.
CAUTIONS:
• Use only the speakers of the SPEAKER IMPEDANCE
indicated by the speaker terminals.
• Do not connect more than one speaker to each speaker
terminal.
Connecting the speakers
1
2
1 Twist and remove the insulation at the end of
each speaker cord.
2 Press and hold the clamp of the speaker terminal.
3 Insert the speaker cord.
4 Release the finger from the clamp.
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
To center speaker
To right front speaker
To right surround speaker
3
4
To left
front speaker
To left surround
speaker
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents