Generator Operation - Winnebago SunCruiser User Manual

SECTION 6 –
ELECTRICAL
Automatic Power Transfer Box
(Located inside or behind
utility compartment)
-Typical Installation
Automatic Generator Start (AGS)
-If Equipped
The Automatic Generator Start feature
monitors house battery voltage and coach interior
temperature, and has the ability to automatically
start the Generator to help maintain full air
conditioning function and house battery charge.
The AGS control pad is also equipped with an
hourmeter feature, which registers the total
number of hours that the generator has been
operated.
AGS Control Pad
(Located near monitor panel)

Generator Operation

(if equipped with AGS)
To Start the Generator
Press and Hold the "Start/Preheat" button on
the AGS Control Pad until you hear the
Generator running smoothly, then release.
6-6
To Stop the Generator
Press and Hold the "Stop/Prime" button on the
AGS Control Pad until you hear the Generator
come to a full stop, then release.
• Press and • Press and
Hold to start Hold to stop
Generator Generator
NOTE: Your coach may be equipped with two
additional Generator power switches
(located on the dash and on the
generator itself), depending on model.
The following label is located near the 120-
volt house circuit breaker panel and at the
Generator to warn you to disconnect specific
electrical connections before servicing the
Generator and storing the coach.
See the AGS user guide for more information
to help understand the AGS feature and its
operation with your Generator.
Generator Operation
(Not available on coaches equipped with
AGS)
NOTE: If the GenSet Start or Stop switch is
momentarily pressed, the monitor panel
will automatically try to start or stop the
Generator. It will try 4 times (10 second
crank, 10 second rest).
• Press Up/Down to
scroll to desired
screen for Generator
Hourmeter reading