Electronic Thermostat - Winnebago SunCruiser User Manual

ELECTRONIC THERMOSTAT

(Heating and Cooling)
The Thermostat (located near the monitor
panel) controls the propane furnace, as well as
the two separate roof air conditioners in your
coach. The living area and galley are equipped
with one air conditioner, and the bedroom and
bath area are equipped with another.
When controlling the settings from the
Thermostat, you must manually press the "Zone"
side of the Mode/Zone button and set to your
preference by toggling to either Zone 1, Zone 2,
or both.
• ZONE 1 - Living/Galley Area
• ZONE 2 - Bedroom/Bath Area
The Thermostat system will operate in both
heat and cool modes, but will not allow you to
run both heat and cool modes simultaneously.
LCD Display Screen
Thermostat Switch
COOL = Air Conditioning
HEAT = Furnace
Electronic Thermostat
(Located near monitor panel)
-Typical View
Setpoint Buttons
Mode/Zone
Button
APPLIANCES AND SYSTEMS
Zone 1 Operation
(Living Area/Galley)
Zone 2 Operation
(Bedroom/Bath)
NOTE: The Thermostat does not automatically
switch between heating and cooling. You
must place the Thermostat switch in the
desired position.
Heating
1. Open the LP gas tank valve by turning fully
counter-clockwise.
2. Select Zone.
3. Slide the Thermostat switch to the "Heat"
position.
4. Press the "Mode" side of the Mode/Zone
button and toggle between settings to select
either "Gas Heat" (for Propane Furnace) or
"Heat Elec" (for Heat Pump).
5. Adjust the temperature setpoint to personal
preference if needed. See "Changing
Temperature Setpoints."
SECTION 4 –
4-9