Dns Configure; Ddns Configure - Konica Minolta magicolor 2590MF Reference Manual

DNS Configure

Purpose
Options
Default
Range
Notes
When using network scanning and when specifying the SMTP server
as a host name instead of as an IP address, be sure to select
"
ENABLE

DDNS Configure

Purpose
Options
Default
112
Sets whether or not the DNS server setting is to be speci-
fied.
If specifying the DNS server setting, the SMTP server can
be specified as a host name when using network scanning.
If "ENABLE" is selected, type in the IP address of the DNS
server.
If "DISABLE" is selected, the DNS server cannot be refer-
enced.
DISABLE/ENABLE
DISABLE
(If "DNS CONFIG." is set to "ENABLE")
0-255 for each xxx triplet
Use the keypad to input each number; use the Left and
Right keys to move between triplets.
A single digit number, such as "1", cannot be input as "001".
Align the number on the left and input "1" as "1 _ _". Use
the * and ) keys to move between triplets.
The Cancel/C key can also be used for deleting. To cancel
DNS Configure menu, hold down the Cancel/C key for
more than one second, and then press the Cancel/C key
again after all settings have been cleared.
After changing the settings, the printer must be turned off,
then on again.
", and then specify the IP address of the DNS server.
Enables or disables DDNS (Dynamic Domain Name Sys-
tem).
If ENABLE is selected, DDNS is enabled.
If DISABLE is selected, DDNS is disabled.
DISABLE/ENABLE
DISABLE
NETWORK SETTING Menu