Table of Contents
Advertisement
Operating Instructions
Operating Instructions: Before operating the car wash, you must first place
the two drying figures and the car on the base. Insert the tabs on the bottoms
of the drying figures into their slots in the following order: The man wearing
the white shirt goes in the slot nearest the car wash exit, and the man in the
gray shirt goes in the slot farther from the car wash exit. Place the car on the
tab in its track. See the diagram on page 5 for the figure and car placement.
Once the car wash is wired to receive at least a 14-20 volt power supply from
the transformer and the transformer is turned on, simply press the activation
button to begin the car wash sequence.
The car starts, pulls forward to the window to talk to the attendant and pay for
the car wash, and pulls around to the car wash doors. The doors open to
allow the car to enter. The car spends about 15 seconds in the car wash,
during which time the smoke unit will supply car wash "mist" and the "Rinse"
light will activate. The car pulls out through the rollers and stops at the red
light for a dry. Finally it pulls around to the two figures who buff the car, then
pulls away. The car wash doors shut after the car has cleared the car wash.
The car wash completes all of these actions by itself, with just the initial press
of the activation button.
The motion and sound can be stopped at any time by turning the power off or
by pressing the transformer's "Direction" button. Once the power is returned,
the car will return to its starting position without sound effects.
4
Advertisement
Table of Contents
