Table of Contents
Advertisement
1
To access and change the other lights: Remove the clear shield over the
rollers. Remove the four (4) recessed screws from the bottom of the car
wash, turn it back over, and tilt the car wash housing to reveal the lights.
You will also need to unplug some of the connections from the PCB to
remove the housing. Refer to the PCB Diagram on page 8.
1. Smoke Unit wiring is red and white and connects into port SD
2. Garage Door Light wiring is gray and white and connects into port SL
3. Building Light wiring is green and white and connects into port CL
4. "Speedee" Sign Light wiring is gray and white and connects into port AD
2
Building Light: Twist the light bulb counterclockwise to remove it. Push
the replacement bulb in and twist it clockwise.
Garage Door Light: Gently pull out the light. To replace it, simply push
3
the new light in, just like the rinse and dry lights.
Sign Lights: Gently pull the sign down and out. Pull the side off the sign
4
to expose the lights. Pull the lights out and push the new ones in to
replace them, just like the garage door lights.
Building
2
Lights
6
1
Clear Shield
Over Rollers
Garage Door
3
Lights
Sign
4
Lights
L
Advertisement
Table of Contents
