Table of Contents
Advertisement
The RailKing Car Wash is made up of three components: the car wash
building and base, the car, and the activation button. Before you place the
car wash on the layout, you must wire the car wash to the activation button
and power source. In order to connect power to each component, the six
(6) enclosed wires must be connected to the wiring posts located on the
underside of the car wash and the activation button. Wires from ports A-C
control the car operation. Wires from ports D-E control the lights. Follow
the diagram (Fig 1) shown to make the correct connections.
A
Connect Red wire to
transformer AC and
connect Black wire to
activation button
Connect Black wire to
B
transformer ground
Connect Black wire to
C
activation button
D
Connect Red wire to
transformer AC
E
Connect Black wire to
transformer ground
Fig 1. Wiring Diagram and Location of Smoke Unit ON/OFF Switch
Strip Z-wire cable harness
insulation to reveal 1/4" of
bare wire.
A
B
Smoke Unit ON/OFF Switch
C
D
E
2
Advertisement
Table of Contents
