Technomate TM-500 User Manual page 28

3. Operation & Setting
4.Open Technomate Control Center and set up the COMPort.
5.Click on File and then go to Files of Type and click on the Down arrow next
to it. Select Image (.img). Select the Serial Image (noboot) and click on
Open.
6.Press the OK button on the front panel of the TM-500/600 to start
downloading. If it does not work, press the OK button again.
7.When it says Done on the receiver and Download Completed on the PC,
turn the AC Power Off/On.
SOFTWARE UPDATE VIA ETHERNET
1.Download Technomate Control Center Loader Program from
www.technomate.com and Open it
2. un the control center loader
3.Go to 'Config' menu & type the IP address
and password of your TM-500/600.
(Refer to the IP address as Menu
(5)Expert Setup (1)Communication
Set up or press just 'LAN' button on the
remote control unit.)
4.Go to 'Update' menu & select 'UPDATE' icon.
5.Select the *.img file & Download/Upgrade procedure will be done automatically.
(TM-500/600 will reboot after the upgrade has finished)
SOFTWARE UPDATE VIA USB MEMORY S
1.Copy all the files in to a USB stick
2.Insert the usb stick into the usb port on the front of TM-600
3.Go to Software update USB update menu
4.select the file in the usb stick & click OK button
5.Upgrade will be done automatically
53
(6)Setup
* REMOTE CONTROL CUSTOMIZATION
Press the [MENU] button to go to the Main Menu. Go to - (6)Setup
(6)Expert Setup (4)Remote Control
Use the [LEFT/RIGHT Navigation buttons to adjust the Repeat Rate and
Repeat Delay.
To change the Style, go to Remotecontrol Style and press the [OK] button
to open a dropdown list. Select a Style and press [OK].
Adjust Next Char Timeout value to what you want.
Press the [GREEN] or [OK] button to save.
* Customizing Expert Setup
54