Table of Contents
Advertisement
3. Operation & Setting
SATELLITE INSTALLATION & TP EDIT
* SATELLITE CONFIGURATION
To set up your satellite configuration, refer to "
* SATFIND
Press the [MENU] button to go to the
Satellite Installation & TP Edit
(2)
This menu allows you to clear see the SNR, AGC and BER. Choose a satellite
and transponder from the dropdown list.
35
3.1 Getting started
".
Main Menu
. Go to - (6)
Setup
Satfind.
(2)
Adjust the dish towards the desired satellite until you have a high value on the
Signal strength AGC and on the Signal quality SNR indicator.
BER should always indicate a value of zero if the Satellite is locked and
synced.
SNR
: Signal to Noise Ratio. This Indicator shows the Signal Strength.
AGC
: Automatic Gain Control. This Indicator shows the Signal Quality.
BER
: Bit Error Rate. This Indicator shows the Signal Errors Rate.
* AUTOMATIC SATELLITE SEARCH
Go to Automatic MultiSat Search (press the [MENU] button to go to the
Setup
Main Menu). Go to - (6)
(2)
(5)
Automatic Satellite Search
and select the satellite that you want to
scan from the dropdown list. Press the [
* AUTOMATIC MULTISAT SEARCH
To scan more than one satellite all at once, go to Automatic Multisat Search
(press the [MENU] button to go to the Main Menu. Go to - (6)
Satellite Installation & TP Edit
(2)
Satellite Installation & TP Edit
GREEN
] button to scan.
Setup
Automatic Multisat Search
(6)
36
Hide quick links:
Advertisement
Table of Contents
