To Insert And Remove The Battery - Petsafe Bank Control Operating Manual

Important: For comfort, safety and effectiveness of product, please ensure
the following:
• Check the fi t to prevent excessive pressure by being able to insert one
fi nger between the Contact Point and your pet's skin.
• Your pet must be carefully examined daily for any signs of a rash or sore.
• If a rash or sore is observed, discontinue the use of the Bark Control Collar
for a few days.
• If the condition persists beyond 48 hours, see your veterinarian.
• Your pet's neck must be washed weekly with a wash cloth and mild hand
soap, then rinsed thoroughly.
A condition called Pressure Necrosis, which is a devitalization of the skin
due to excessive and prolonged contact against the Contact Points, may
occur if the steps above are not followed.
____________________________________________________________________
ON/OFF Battery Module
The Petsafe Bark Control Collar
®
installed in the "OFF" position. To activate the collar, use a coin to turn the
Battery Module counter clockwise until the arrow lines up with the "ON"
position. If the Petsafe Bark Control Collar is not going to be used on the dog
immediately leave it in the "OFF" position.

To Insert and Remove the Battery

Note: Do not install the battery while the Bark Control Collar is on your dog.
1. Align the triangles on the battery and
the Bark Control Collar (A).
2. Use a coin to turn the battery clockwise
until the triangle lines up with the "On"
position if you are putting it on the dog
or the "Off" position if it is not being
put on the dog right away (B).
8
is packaged with the battery module
™
A
1-800-732-2677
B
Coin