Petsafe Bank Control Operating Manual page 7

5. The Bark Control Collar should fi t snugly, yet
loose enough to allow one fi nger to fi t between
a Contact Point and your dog's neck. Allow
your dog to wear the collar for several minutes,
then recheck the fi t. Check the fi t again as your
dog becomes more comfortable with the Bark
Control Collar.
6. Trim the collar as follows:
a. Measure 4 1/2" from the tongue of the metal buckle and mark with a pen.
b. Remove the Bark Control Collar from your dog and cut off excess.
____________________________________________________________________
ID Tag Ring
Use the ID Tag
Ring to attach your
dog's ID tags to the
collar. Simply place
the ID Tag Ring
through one of
the holes on your
collar. Make sure
to place the Ring
far enough from the receiver housing so that the tags will not hit the Receiver
or the Contact Points.
Important: Do not attach a leash to the collar.
This can result in pulling the Contact Points too
tightly against your pet's neck. Attach a leash to a
separate, non-metallic collar or harness, making
sure the extra collar does not put pressure on the
Contact Points.
www.petsafe.net 7