Changing The Picture Tone; Changing The Display Brightness; Setting The Clock - JVC MX-DK1 Instructions Manual

Changing the Picture Tone

While showing a playback picture on the TV, you can select
the preset picture tone, or adjust it and store your own
settings.
To select a preset picture tone
1
While playing, display VFP setting screen.
(While holding...)
2
Select a preset picture tone.
NORMAL
Normally select this.
CINEMA
Suitable for a movie source.
USER1/USER2 You can adjust parameters and can
store the settings (see below).
To adjust the picture tone
1
Select "USER1" or "USER2."
• Follow steps 1 and 2 explained above.
2
Select a parameter you want to adjust.
GAMMA Adjust if the neutral color is bright or
dark (–3 to +3).
BRIGHTNESS Adjust if the picture is bright or dark
as a whole (–8 to +8).
CONTRAST Adjust if the far and near positions
are unnatural (–7 to +7).
SATURATION Adjust if the picture is whitish or
blackish (–7 to +7).
TINT Adjust if human skin color is
unnatural (–7 to +7).
SHARPNESS Adjust if the picture is indistinct (–8
to +8).
Remote
ONLY
NORMAL
0
GAMMA
0
BRIGHTNESS
0
CONTRAST
0
SATURATION
TINT 0
0
SHARPNESS
On the TV screen
NORMAL CINEMA
USER2 USER1
3
Adjust the parameter.
4
Repeat steps 2 to 3 to adjust other parameters.
To remove the setting screen, while holding SHIFT, press
VFP again. The screen will automatically be erased after 9
seconds even if you do not press VFP.

Changing the Display Brightness

You can dim the display window.
(While holding...)

Setting the Clock

Remote
ONLY
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, while holding SHIFT,
press CANCEL.
1
Activate clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock time starts flashing.
2
Adjust the hour, then minute.
To check the current time when the System is turned on
(While holding...)
Remote
ONLY
DIMMER ON
DIMMER OFF
(Normal)
INFO
14