Trouble Shooting Guide - Daewoo DW-5010 Service Manual

4. TROUBLE SHOOTING GUIDE

NOTES
Pull out the power plug prior repair and make sure that the Washing machine has been properly grounded.
C o n c e r n i n g W a s h
PROBLEM
Is the Power properly
PULSATOR
DOSE NOT
ROTATE.
Is the contact of Wash
Are the Pulsator and
Motor Pulley securely
PULSATOR
Does the V-Belt slip?
DOES NOT
ROTATE
SMOOTHLY.
between the Pulsator
Does the pulsator shaft
rotate propely when the
pulsator has been disas-
8 TROUBLE SHOOTING
CHECK POINT
NO
connected?
YES
Is there a whirring
sound from the
Wash Motor when
turned on?
YES
NO
Is the Condenser
properly connected?
NO
YES
Is the Motor hot?
(In case there is
Thermal Protector)
NO
NO
Is the Wiring good?
(Refer to the Wiring
Diagram)
YES
NO
Timer good?
YES
NO
Is the wash load
appropriate?
YES
NO
assembled?
YES
YES
NO
YES
Are there impurities
and Tub.
NO
YES
sembled?
NO
CAUSE
Motor does not start due to
opening the Condenser circuit.
Power has been cut off by the
Thermal Protector
Improper wiring.
Defective Wash Timer.
Defective Wash Motor.
Defect of mechanical
assembly.
Worn out V-Belt.
Revolution obstructed by
impurities.
Worn out the Serration
within the pulsator.
Defective Case Shaft As.
SOLUTION
Reconnect the Power
Cord.
Reconnect the
Condenser.
Power restored when
Motor cools
Reconnect the wiring.
Replace Wash Timer.
Replace Wash Motor.
Reload with proper wash
load.
Tighten the screws fixed
on the Pulley.
Replace V-Belt
Remove impurities after
disassembling pulsator.
Replace pulsator.
Replace Case Shaft As..