Daewoo DW-5010 Service Manual page 10

PROBLEM CHECK POINT
Is the wiring of
Condenser properly
connected?
PULSATOR
YES
ROTATE ONLY
Is the wiring of wash
IN ONE
timer properly
DIRECTION.
connected?
YES
Are there strange noise
from Tub when the
Pulsator rotates?
THERE IS
EXCESSIVE
NOISE
NO
DURING
WASHING.
Concerning Spin
PROBLEM CHECK POINT
Is there a whirring
sound form the Spin
Motor when turned ON?
Is the Condenser
NO
THE SPIN
Is the Motor hot?
(In case there is
DRYER DOES
Thermal Protector)
NOT ROTATE.
NO
Is the Wiring good? (Refer
to the Wiring Diagram)
YES
Is the contact of Spin
Timer good?
YES
NO
NO
Defective Wash timer.
YES
Impurtities between
Pulsator improperly
Something is in contact
with the Pulsator Pulley or
Motor Pulley or other
YES
NO
Motor does not start
properly due to opening the
connected?
YES
Power has been cut off by
the Thermal Protector
NO
NO
Defective Spin Timer
Defective Spin Motor
CAUSE
Improper wiring.
Improper wiring.
Pulsator and Tub.
NO
assembled.
rotationg parts.
CAUSE
Condenser circuit.
Improper wiring.
SOLUTION
Reconnect.
Reconnect the Wash
Timer
Replace Wash Timer.
Remove impurities after
disassembling Pulsator.
Tighten the Pulsator
fixing screw.
Adjust the parts so that
there are no impurities in
contact with rotating
parts.
SOLUTION
Reconnect.
Power restored when
Motor cools
Reconnect the wiring.
Replace the Spin Timer.
Replace the Spin Motor.
TROUBLE SHOOTING 9