Recording; Recording From The Radio - JVC Micro Component System SP-UXH9 Instructions Manual

Recording

IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable program and in any
literary, dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the other sound settings. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can only use type I tape for recording.
• DO NOT turn off the unit while playing back or
recording a tape. The cassette deck or tapes
may be damaged.
• DO NOT use type II and type IV tapes since the
unit is not compatible with such tapes.
• The use of C-120 or longer tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.
At the start and end of cassette tapes
There is leader tape which cannot be recorded onto. Thus, when
recording from discs, FM/AM broadcasts, or external equipment,
wind the leader tape first to ensure that the recording will be made
without losing any music.
To protect your recordings
Cassettes have two small tabs on the back to protect against
unexpected erasure or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
17

Recording from the Radio

On the unit ONLY:
1
2
3
4
5
• If no cassette is inserted.
• If a protected tape is inserted.
To stop recording for a moment, press *
(pause).
To resume recording, press * again.
To stop recording, press &/).
To remove the cassette, press &/) while
recording is stopped.
Adhesive tape
To record an AM (MW) station—Beat Cut
On the remote control ONLY:
While recording an AM (MW) broadcast, beats
may be heard (which are never heard when
listening to the broadcast without recording it).
If this occurs, press BEAT CUT repeatedly, while
recording, until the beats are reduced.
• Each time you press the button, the display changes
Put a recordable cassette in with the exposed
part of the tape down.
• See also page 16.
Close the cassette holder gently.
Press TUNER/BAND to select either
"FM" or "AM."
• When recording from discs, see "Recording
Discs—Disc Synchronized Recording" on page
18.
Tune in to the station you
want to record.
Press ‡ (recording).
‡ and # lock down, and the recording starts.
You cannot press ‡ in the following cases:
alternates "BEAT 01" and "BEAT 02."
BAND
TUNER
BEAT CUT