OHAUS Traveler TA152 Instruction Manual
Hide thumbs
Also See for Traveler TA152:
- Instruction manual (65 pages) ,
- Service manual (49 pages) ,
- User manual (29 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for OHAUS Traveler TA152
Summary of Contents for OHAUS Traveler TA152
- Page 1 Traveler Scales Instruction Manual...
-
Page 3: Safety Precautions
™ EN-1 Traveler Scales 1. INTRODUCTION This manual contains installation, operation and maintenance instructions for the Traveler Scales. Please read the manual completely before using the scale. 1.1 Safety Precautions Please follow these safety precautions: • Verify that the Power Adapter input voltage matches the local power supply voltage. •... -
Page 4: Installation
EN-2 ™ Traveler Scales Key Name Function • Primary function (Short Press)– Advances to next available unit Unit • Menu function – (No) This key is used to reject the displayed setting and advance to next available setting 2. INSTALLATION 2.1 Package Contents •... -
Page 5: Connect Power
™ EN-3 Traveler Scales 2.4 Connect Power A Power Adapter is used to power the scale. Connect the Power Adapter to the power outlet (see Figure 2-3) and the power plug to the back of the scale (see Figure 2-4) For use only with UL or CSA Certified (or equivalent approved) power adapter, which is a Class 2 or a... -
Page 6: Initial Calibration
EN-4 ™ Traveler Scales 2.6 Initial Calibration Power on the scale by pressing On-Zero. Allow at least one minute for the scale to stabilize CAL] is displayed. The display before calibrating. Press and hold the Print/Cal button until [CAL flashes [- - - - C C C C - - - - ] while zero reading is taken. The display flashes the required span mass. Put the indicated calibration mass on the pan and press Yes. -
Page 7: Menu Structure
™ EN-5 Traveler Scales 3.2 Weighing Mode Press Unit to advance to next available weighing Unit. Press Zero to zero the scale and then place objects to be weighed on the pan. 4. SETTINGS The Settings allows the user to customize the scale. 4.1 Menu Structure Table 4-1 illustrates the menu structure. -
Page 8: Setup Menu
EN-6 ™ Traveler Scales S.E.t.U.P.] S.E.t.U.P S.E.t.U.P 4.2.1 Setup Menu [S.E.t.U.P The Setup menu contains the following sub-menus: Auto-Off [.A A A A - - - - OFF. OFF. OFF.]: OFF. Auto Off settings: On Off Setting [On] will automatically turn the scale off after no activity is detected for 4 minutes. -
Page 9: Maintenance
Weigh Below Hook access hole Figure 4-2. Setup for using the Weigh Below Hook. 5. MAINTENANCE 5.1 Troubleshooting The following table lists common problems and possible causes and remedies. If the problem persists, contact Ohaus or your authorized dealer. - Page 10 Calibration Lock switch is set Slide the switch to the unlocked position. Err 1 Invalid Checksum data. Cycle scale off/on. Contact Ohaus or authorized dealer. Err 2 Over-load or Under-load Verify pan is installed and/or excess load condition. is removed from pan.
-
Page 11: Service Information
Ohaus service agent. For service assistance or technical support in the United States call toll-free 1-800-526-0659 between 8.00 AM and 5:00 PM EST. An Ohaus product service specialist will be available to provide assistance. Outside the USA, please visit our web site, www.ohaus.com, to locate the Ohaus office nearest you. - Page 12 TABLE 6-2. ACCESSORIES ACCESSORY PART NUMBER RS232 Interface Kit 72206287 USB interface Kit 72206288 Specific Gravity Kit 72202685 Security Device 76288-01 Auxiliary Display TAD7 Printers See www.ohaus.com, or contact dealer Adapters, RS232 to Printer Calibration masses 6.3 Drawings Figure 6-1. Overall Dimensions...
- Page 13 Thank you for your contribution to environmental protection. ISO 9001 Registration In 1994, Ohaus Corporation, USA, was awarded a certificate of registration to ISO 9001 by Bureau Veritus Quality International (BVQI), confirming that the Ohaus quality management system is compliant with the ISO 9001 standard’s requirements. On May 15, 2003, Ohaus...
-
Page 14: Limited Warranty
Ohaus. In lieu of a properly returned warranty registration card, the warranty period shall begin on the date of shipment to the authorized dealer. - Page 16 / Weltweite Geshäftsstellen / Con uffici in tutto il mondo *80251716* P/N 80251716 B © 2010 Ohaus Corporation, all rights reserved / todos los derechos reservados / Tous droits réservés / Alle Rechte vorbehalten / tutti i diritti riservati Printed in China / Impreso en China / Imprimé...
Need help?
Do you have a question about the Traveler TA152 and is the answer not in the manual?
Questions and answers