OHAUS TAJ Series Quick Start Manual

Quick Start Guide

PREPARATION FOR USE

Install Pan, Release Locks
Install the metal pan over the sub-platform.
Before using the scale, release the
Transportation Lock. On the scale bottom,
slide the locking pin to the
Calibration Lock: to change, see Instruction
Manual. (Otherwise leave as is.)
Check Power
Voltage rating on scale's power adapter must
match local line voltage. If not, contact an
Ohaus dealer. To use battery power, remove
battery cover and insert LR6 (AA) batteries.
Set Draft Shield (Carat models –

SAFETY PRECAUTIONS

For safe and dependable operation of this product, please comply with the following
safety precautions:
Verify that the input voltage printed on the power Adapter and the plug type matches
•
the local power supply.
Make sure that the power cord does not pose an obstacle or tripping hazard.
•
Disconnect the product from the power supply when cleaning.
•
Do not operate this product in hazardous or unstable environments.
•
Do not drop loads on the pan.
•
Use only approved accessories and peripherals, as available.
•
Operate the product only under ambient conditions specified in the Instruction Manual.
•
Service should be performed by authorized personnel only.
•
Ohaus Corporation www.ohaus.com
Communication
Interface
compartment
position.
(See page 3.)
)
see page 3.

SELECTING THE LOCATION

Place on a firm, steady surface.
Avoid locations with excessive air current,
vibrations, heat sources, or rapid temperature
changes.
Level the scale: Adjust leveling feet so bubble
is centered.
i
TAJ Series
Leveling
Bubble
Leveling
Feet
TAJ Carat & Gold Series Quick Start Guide
Power Input Jack
Transportation
Lock
Remove
Battery
Cover to
insert
Batteries:
LR6 (AA).
Calibration
Lock