Toshiba PORTÉGÉ R700 Series Maintenance Manual page 315

4.7 HDD/SSD
6. Remove the following screws securing the SSD.
• M1.4×3B
7. Remove the SSD from the SSD holder.
SSD holder
Installing the SSD (1.8-inch)
To install the SSD (1.8-inch), follow the steps below and refer to Figure 4-7, 4-9 and 4-10.
1. Set the SSD to the HDD holder and secure them with the following screws.
• M1.4×3B
2. Set the SSD holder (with the SSD) into the slot.
3. Connect the SSD FPC to the connector on the SSD.
4. Stick the insulators (SQUARE INSULATOR and SSD HOLD INSULATOR) in
place.
5. Set the HDD/SSD cover and secure it with the screw.
PORTÉGÉ R700 Maintenance Manual (960-833)
S-THIN HEAD
M1.4x3B S-THIN HEAD
Figure 4-10 Removing the SSD (1.8-inch) (2)
S-THIN HEAD
4 Replacement Procedures
×4
SSD
×4
[CONFIDENTIAL] 4-21