Truss installation
1.Bolt each clamp (1) to the omega holder (3) with M12 bolt and lock nut through the hole in the holder.
2.Fasten the omega holders on the bottom of the base by inserting both quick-lock fasteners (4) into the holes
of the base and tighten fully clockwise.
3. Pull the safety wire (2) through the carrying handles (5) and around the truss (6) as shown on the pictures
below.
......Securing the fixture via one safety wire
Before taking into operation for the first time,the installation has to be approved by
When installing fixtures side-by-side,
avoid illuminating one fixture with another!
DANGER TO LIFE!
an expert!
Securing the fixture via two safety wires
1-Clamps
2-Safety wire
3-Omega holder
4-Quick-lock fastener
5-Carrying handles
6-Truss