Table of Contents
Advertisement
Note: In the case of an interruption of the upload process (e.g. power cut), the fixture keeps the updating mode
and you have to repeat the software update again.
7.7 Icon "Lamp menu"
Lamp Status.- The item enables to switch the lamp on/off...
Settings.- The menu offers many items for setting of lamp behaviour.
Lamp Ignition Delay - The item allows to set the time delay( 0-90sec.) before igniting the lamp by DMX
command. If the lamp is started directly from the control panel, the time delay will be ignored.
....Lamp On/Off Settings - Use the menu to set rules for automatic switching on/off the lamp.
Lamp On Power On - If the item is on, the lamp will be automatically turn on after switching the
fixture on.
....
Lamp Off via DMX.- The item enables to switch the lamp off via DMX command from DMX
controller.
Lamp On if DMX Present - The item allows you to strike the lamp automatically after 26 seconds
.
if DMX signal is present on the fixture´s DMX input.
Lamp Off if not DMX - The item allows you to switch off the lamp automatically after 2 minutes
if DMX signal is missing on the fixture´s DMX input.
...Green mode - If this item is set on, the lamp power at shutter=0 DMX will be reduced to 20% of its nominal
power. This setting can be temporarily overwritten by the DMX value at the channel "Power/Special
functions" (ranges of 30-39 DMX and 40-49 DMX).
...Note: because the plasma source comes up from 20% of its nominal power to the full power typically
within 15seconds after opening blackout, some colour changes may be visible during this time
period.
.
This fixture supports RDM operation. RDM (Remote Device Management) is a bi-directional communications
protocol for use in DMX512 control systems, it is the new open standard for DMX512 device configuration and
status monitoring.
The RDM protocol allows data packets to be inserted into a DMX512 data stream without adversely affecting
existing non-RDM equipment. By using a special „Start Code," and by complying with the timing specifications
for DMX512, the RDM protocol allows a console or dedicated RDM controller to send commands to and receive
messages from specific moving lights.
RDM allows explicit commands to be sent to a device and responses to be received from it.
The list of commands for Robin 300 Plasma Spot is the following.
Parameter ID
DISC_UNIQUE_BRANCH
DISC_MUTE
DISC_UN_MUTE
DEVICE_INFO
SUPPORTED_PARAMETERS
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
IDENTIFY_DEVICE
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SENSOR_DEFINITION
SENSOR_VALUE
DISPLAY_INVERT
DISPLAY_LEVEL
PAN_INVERT
TILT_INVERT
8. RDM
Discovery command SET command
*
*
*
5
GET command
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
Advertisement
Table of Contents
