Power Interposer Board And Power Distribution Board; Removing The Power Interposer Board - Dell PowerEdge T630 Owner's Manual

Power interposer board and power distribution board

Removing the power interposer board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
CAUTION: To prevent damage to the power interposer board (PIB), you must remove the
power supply module(s) from the system before removing the power interposer board or
power distribution board (PDB).
3. Remove the power supply module(s) from the back of the chassis.
4. Remove the PCIe card holders.
5. Remove the cooling shroud.
6. If applicable, remove the cooling fan assembly.
7. Disconnect the power cables to the system board and the hard-drive backplane.
8. Remove the system board. For more information, see
Steps
1. Pull the release pin and detach the PIB from the PDB.
2. Slide and lift the PIB up until the grooves on the PIB disengage from the pins on the chassis.
138
Safety instructions.
Before working inside your system.
Removing the system board.