Helmet Holding Cable - Yamaha MT-07 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Helmet holding cable

A helmet holding cable is located on
the bottom of the passenger seat. Use
this cable in conjunction with the
screwdriver to secure a helmet to the
3
vehicle.
1
3
1. Passenger seat
2. Helmet holding cable
3. Screwdriver
To secure a helmet with the helmet
holding cable
1. Remove the passenger seat. (See
page 3-19.)
2. Remove the screwdriver from its
holders on the passenger seat,
and then remove the helmet hold-
ing cable from the screwdriver.
EAU59981
TIP
When removing the screwdriver, slide
the screwdriver toward the " " mark
on the passenger seat.
1
2
2
1. Screwdriver
2. " " mark
3. " " mark
3. Pass the helmet holding cable
through the buckle on the helmet
strap.
4. Hook the cable loops over the
screwdriver, install the screw-
driver by first inserting the screw-
driver into the holder with the " "
mark, and then slide the screw-
driver toward the holder with
the " " mark.
TIP
Make sure that the screwdriver is se-
curely positioned between its holders,
and then position the cable loops to-
ward the middle of the screwdriver be-
fore installing the passenger seat.
3
1. Helmet
2. Helmet holding cable
3. Screwdriver
4. Holder
5. Install
3-21
1
2
3
the passenger
WARNING! Never ride with a
helmet attached to the helmet
holder, since the helmet may hit
objects, causing loss of control
and possibly an accident.
4
seat.
[EWA10162]