Kenwood KVT-719DVD Service Manual page 34

KVT-719DVD/729DVD
/729DVDY/739DVD
[Key specifi cation]
Init: Select the item to be initialized.
■Start: Pressing and holding (for 2 seconds or longer)
initializes the selected item's information.
Serial: Move on to Serial No. Manual Input screen.
Clear: Clear Chroma data or DC Offset information in the
E2PROM.
DVD Service INFO: Switch DVD video and display DVD
service information using "B/E OSD".
Tuner Mute Level: Move on to the Tuner Mute Level
Adjustment screen.
DV D D i v X R e g i s t r a t i o n C l e a r : C l e a r DV D D i v X
Registration Code.
Return: Move on to Test Mode Main screen.
● Service Information
Select the item to be initialized by pressing the [Init]
key (multiple items can be selected/selected items are
highlighted).
After selection is completed, press and hold the [Start]
key for 1 second or longer to initialize the displayed
service information.
● Chroma
Chroma information is normally displayed as "Ready" and
"CLR OK/NG" when E2PROM data is cleared.
When not completing Reset after Clear, setup data is not
modifi ed. After resetting, cleared data is refl ected.
In case of "KOS" series, clear Chroma data; touch
correction value and HPOSI correction value in E2PROM.
● DC Offset
When DC Offset detection information is shown as "None",
offset is not detected. When it is shown as "Detect (x)",
offset is detected. X=0~3: Number of capacitor leaks
detected.
Clear the detection information with the [Clear] key.
● DVD DivX Registration Code
Display Registration Code of DivX and clear the Code
with the [Clear] key.
After clearing the Code, "None" will be displayed.
* Clear the code only after ejecting the disc.
● DVD Service INFO
Switch DVD video and display DVD service information
using "B/E OSD".
Use the [DISP] key and CURSOR (right or left) on the
1
remote controller* to feed pages.
34
TEST MODE
Press [VSEL] key or [FNC] key to return from DVD image
to Service screen.
Once the DVD Image screen is shown by selecting the
DVD Service INFO, the OSD is no more displayed on the
DVD image screen. Re-start the set by recycling the ACC/
Power (i.e., ACC/Power Off→On) to display the OSD on
the DVD Image screen.
*1: RC-DV430 (DVD MODE)
2-3-4. Serial No. Entry screen
Enter the serial code of each set from this screen.
Serial No. Entry screen is shown in Figure 2-3-4.
Clear
Clear
Figure 2-3-4 Serial No. Entry screen
[Key specifi cation]
0~9: 10key for entering the serial No.
Clear: Clear the serial No. which is being input.
Cancel: Move on to Service screen.
Enter: Start entering the serial No.
(When entry is successfully completed, "Write OK" is
displayed. When entry is not successful, "Write NG" is
displayed)
When "Write OK" is displayed, use this key to move on to
the Service screen.
If "Write NG" is displayed, transfer to the test mode again
and repeat entry from the fi rst step.
– – – – – – – –
1 2
4 5
7 8
0
Cancel
↓
∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
Cancel
3
6
9
Enter