Mitsubishi Electric Mr.SLIM PC-2GAKD Technical & Service Manual page 42

Selecting functions using the wired remote controller
1 Check the function selection setting.
2 Switch to function setting mode.
(Press A and B at the same time
with the remote controller stopped.)
3 Specify address.
4 Specify unit No.
Refer to address and unit No. to the figure
below.
6 Select mode No. 02
(room temperature detection position).
7 Select setting No. 03 (remote controller fixed).
(Use F and G .)
0 Ending of function display
(Press A and B at the same time.)
1 : 1 system
Outdoor unit
Indoor unit
Remote controller
Indoor unit
address = 00
unit No. = 01
(Use C and D .)
(Specified indoor unit:
5 Enter the setting.
FAN operation)
(Press E .)
Example:
8 Enter the setting.
Selecting room temperature
(Press E .)
detection position
NO
Finished
YES
The above procedure must be carried out only if changes are necessary.
Simultaneous twin system
Outdoor unit
Main
indoor unit
Remote controller
Main indoor unit
address = 00
unit No. = 01
For modes 15 and higher,
press J and B at the same time.
NO
Outdoor unit
Sub Main
indoor unit indoor unit
Sub indoor unit
address = 01
unit No. = 02
42
YES
Change address
and unit No.
9
Rotation system
Outdoor unit
Sub
indoor unit
Remote controller
Main indoor unit Sub indoor unit
address = 00 address = 01
unit No. = 01 unit No. = 01