Connecting The Speakers - JVC FS-5000 Instructions Manual

CAUTION: Make all connections before plugging the System into an AC power outlet.

Connecting the Speakers

1. Open the Speaker terminals on the rear of the Unit, and on the Speakers themselves.
2. Connect the speaker cords between the terminals as shown below.
Connect the cords with a black line to the (–) terminals and cords without a black line to the (+) terminals.
Close each of the terminals to securely connect the cords.
CAUTION: A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.
Removing the speaker grilles
The speaker grilles can be removed.
When removing,
1. Insert your fingers at the top and pull towards you.
2. Also pull the bottom towards you.
Connecting an MD Recorder/Tape Deck
Connect (optional) signal cords between the System's MD/TAPE IN/OUT terminals and the output/input terminals of the external MD recorder,
tape deck, etc.
You can then listen to the external source through the System, or record the System's CD player or tuner to the external unit.
R
Right speaker (rear side)
Marked with a black line
SPEAKERS
LEFT
RIGHT
SPEAKER CORD
1
Signal cord (optional)
L
Pin-plug x 2
IN
MD/TAPE
OUT
Signal cord (optional)
Pin-plug x 2
Left speaker (rear side)
2
When Attaching the speaker grille
MD recorder or tape deck (optional)
Pin-plug x 2
Pin-plug x 2
Speaker grille
4